deck post spacing in uk

The basic construction of the deck base, should include accurate measurements and a level or fall to suit the finished deck that you have in mind. However sturdy your decking timbers are, they will be wasted if laid on a poorly constructed sub decking base frame. Decking joists are the basic and the right spacing is 

In this instance the maximum span between deck post centres is 2.07m (C16) or 2.24m (C24). Cut away diagram of finished raise decking by Q-Deck. Annotated decking diagram. Joist and Deck Board Spacing Guidance. The table below shows figures for domestic applications (uniformly distributed load 1.5kN/ m2) and 

For conventional guard rail post installation, bolted to the side of the framing, larger framing will provide for more strength in the rails. For upper level decks 2x10 is recommended as the minimum size to use for strong guard post connections. 2x6 joists should only be used on ground-level decks that do not require, and will 

So by multiplying the length of your proposed deck with its width, you'll be able to calculate your surface area requirements. If you are using a centre spacing of 1m for your posts, you can then use this simple calculation to determine how many posts you'll need to buy Here's the best UK prices for support posts  

I am planning to build some decking at the end of the garden. I planned area is approx 6m wide x 3m deep. How many concreate set wooden posts would be required to support the whole structure up? And at

The span of joists in the information below should only be taken as a guide. Deck joist spacing will be determined by experience and knowledge, as well as the minimum spacings listed. They have been prepared from experience and also reference to Government Building Controls Data, and are based upon load bearings 

instruction for “Timber Fence Post”. Jacksons Fencing Head Office Stowting Common Ashford Kent TN25 6BN. Tel 44 (0) 1233 750393. Fax 44 (0) 1233 750403 www.jacksons-fencing.co.uk info@jacksons-fencing.co.uk. You don't have to be a master carpenter to design & build a timber deck.

FASCIA Deck boards attached vertically to outer subframe for tidy appearance. HAND RAIL. BALUSTER. NEWEL POST. BOTTOM RAIL. DECKING. FASCIA. JOIST If space is restricted you might think about building-in benches and storage planters. To help you think up what your deck will look like it's sometimes helpful.

Attach 50 x 150mm rim joist to post using 7.0 x 100mm Rugged Structural Screw. Reinforce inside corners of rim joists with angle brackets attached with joist nails. Laying Decking. Position deck boards so that ends overhang rim joists and space boards about 3mm apart to provide drainage. Attach decking by driving a pair 

The deck post holes need marking out. This can be difficult and can be made easier if you use some of the joists and put them into position. For the deck in this project we are spacing the joists at 400mm centre's. The decking posts need to be spaced at every metre in each direction. We have marked this onto the ledger and 

Step 5: Fitting Deck Newel Posts. Step 6: Fit The We negotiate exclusive discounts of up to 50% off with 20 UK DIY suppliers, including Wickes & B&Q. All our latest solid footing. If you're building an on-grade deck (a decking structure built just above the ground) then you might not need railings, features, posts or steps.

Secure the deck boards Once you are happy with the layout and spacing of the deck boards, fit and secure them to the bearers with 65mm (no.8 x 2½") decking . Secure the posts to the frame Use coach bolts or screws to secure the deck bearer frame to the posts, working to a 1:80 fall to encourage rainwater drain off, and 

3. Sourcing Materials. 4. Decking Supports. 5. Decking Framework. 6. Laying the Decking. 7. Decking Surrounds. 8. Deck Screening. 9. Deck Steps or Access. 1. Choosing A Site contact with the ground (posts for instance) should be treated for ground contact. It . 01631 563271 or email us at sales@hodgefencing.co.uk.

06 www.arbordeck.co.uk. Fitting the Arbordeck contemporary handrail. The top of the handrail should be 900mm from deck level. Mark this height on the newel post. 45. Ensuring the back rail is square with the newel post fix using two or more galvanised or stainless steel screws. 48. Calculate the spacing required on each.

Leading suppliers of decking in the UK. Stocking a full range of If you want the decking raised pick the height from the drop down box, this height is from ground to top of the deck. Lengths of posts , postmix and You will need to add one newel posts for every time there is a gap in your total length. Spindle are calculated