decking straight on ground

An alternative to deck blocks is to use rectangular patio blocks, laid underneath the corners of the deck and at 4' to 6' intervals directly on the ground. to take on your own DIY outdoor project, or collaborate with a professional builder - it's important to understand the best practices for installing Decking material.

problem cover deck in cost effective solution!!!!!!!!!!!!!!!!! well you blew that straight out of the water laying the decking like that LOL. Read more. Show less. Reply 1. Pigjigger4 years ago. You should really cover your end cuts for a professionally finished look. At least route over the corners going down into 

Install-Decking-Step4. 3. Lay concrete slabs at the corner and centre points of the space you want to deck. The slabs provide a solid, load-spreading foundation for the deck and keep the wooden frame clear of the damp ground. Put a straight piece of wood on top of the slabs and check for level. Get the 

Trim deck straight line - Build Ground-Level Deck. • Snap a chalk line to mark a straight cutting line. Trim decking to length with a circular saw. • Approximate time: 15-30 minutes 

For all your trade and DIY tools and materials visit - www.tradessupermarket.com For DIY videos, expert advice and a great shop all in one visit - htt

Start The Ground Work. Area of garden prepared for decking to be layed. Decking can be positioned virtually anywhere in the garden. If it is going over an existing patio, then you have just saved yourself some hard work as you won't need to create a new foundation, it can go straight on top with a few adjustments if the area 

Learn how to lay garden decking with the most comprehensive guide on the web. Includes In this guide you'll learn that your new deck can be built in just 9 straight-forward steps. If you're building an on-grade deck (a decking structure built just above the ground) then you might not need railings, features, posts or steps.

I ASSUME YOU WANT TO LAY THE TILES DIRECTLY ON THE GROUND AND NOT OVERLAY A PAVED AREA? YOU WOULD HAVE TO GET THE GROUND FLAT AND LEVEL BECAUSE ANY DISCREPANCIES WOULD BE OBVIOUS WHEN LAYING THE TILES. UNFORTUNATELY, THE EFFECT 

This method is acceptable as long as the concrete does not inhibit drainage. Likewise, timber bearers could be laid directly on a well drained gravel/sand or concrete base as long as they are of minimum in-ground Durability Class 1 or H5 treated softwood, and again do not inhibit the drainage of water. A panelised decking.

Spruce Another attractive straight-grained softwood. Spruce is generally only suitable for those parts of the deck which are above ground. Larch Not the most popular softwood decking material. Larch can be expensive and have lots of knots in the wood. Teak A very expensive, but beautiful mid-brown 

Leveling the bricks for garden decking Working from one corner, use a spirit level (on a length of straight timber if necessary) between bricks to make sure that the top of the bricks are reasonably level (this is just a check to remove the need to dig out the ground later). Remove the bricks and lay a weed suppressant 

If your door is very low to the ground you may not have enough room to install deck framing and decking without excavating. Digging a It is a good idea to space your decking to allow the underside of the deck to breathe. Some builders build ground level decks directly on top of existing concrete patios using sleepers.

150mm for the deck joists, 38mm for the boards and 10mm so that the joists don't sit directly onto the soil. The site should be as level as possible after you have dug out. Building the frame. Lay out your decking joists as shown below, with 450mm centres between internal joists and nail together with 4 inch galvanised nails.