how to properly install wood decking

With a little planning and care you can avoid some rookie mistakes such as uneven gaps, raised or missing screw heads, and cracked or split deck boards.

A 1/8-inch gap is a reasonable end-target, but since wood decking often shrinks after it has been installed, this shrinkage must be taken into account during The CAMO tool in the carpenter's hand assures that the proprietary deck screw is driven at the correct position in the edge of the deck board and on the proper angle.

Compared to building a deck foundation, installing decking boards is an uncomplicated and straightforward process. If you are lulled into complacency by the apparent ease of the task, however, you may end up with noticeable imperfections, such as uneven gaps or raised screw heads, and you may waste wood. Although 

We will teach you how to install wood and composite decking material to build the floor surface for your deck. Read our 16 articles explaining hidden fasteners, decking patterns, Picture Frame Decking. Install a picture frame or perimeter board to finish the edge of your deck with style. advertisement. Decking Installation 

Drive a 3/4-in. wood chisel into the joist and tight to the edge of the deck board with the bevel facing you. Pull back on Most deck boards are relatively straight and easy to lay, but there are always a few that need a little extra coaxing. Run the saw's base against the straightedge to cut the deck boards perfectly straight.

How to properly install and finish hardwood decking using edge mount pregrooved and on-site routered Clip hidden deck fasteners and materials.

Deciding on the location is important: do you want a sunny or shaded location and is privacy a requirement? Decks built in permanent shade If the bearers (wood supports that will bear the weight of the decking) are not level, use thin offcuts of treated timber to level them, before laying the deck. On soft ground it is possible 

Want your new deck to last twice as long as others? Going crazy keeping your How to Install Deck Boards Properly. Steve Maxwell I would suggest normal single joist fixing but a pot of top quality timber preservative next to the drop saw and following each cut, dunk the lumber. It will be sucked up into 

Learn what important things to look for in your lumber before putting anything together. Examine each piece and try to put the most attractive pieces in the high-visibility areas. Also If possible, purchase boards that are long enough to span the entire width of the deck, but if the deck is too wide, this may not be possible.