low profile wood deck using 2x4

Let's say that our deck elevation will be 3 feet above the ground, giving us a 36 inch vertical height for the steps. Make a On a second floor deck we would use an entirely different design, to eliminate several of the posts under our deck. There we . We will use the same lengths for the 2x4 rail supports.

I want to build a low profile deck at the back of my house but I don't have enough room from the door sill to the ground to use 2X6 joists. Would 2X4.

Wear gloves and work boots when handling lumber and concrete. (Do not wear gloves when operating power saws.) • Use GFCI-protected power cords when operating power tools outdoors. • Use manufacturer-approved hardware and fasteners for all wood products. Check with the manufacturer or your local supplier for 

The family could watch marsh birds from the top level or sit around a cozy fireplace/barbecue on the lower deck. A grand staircase facing the Having had four years of experience building decks with wood-polymer composites, I suggested decking (www.trex.com), which fit the bill perfectly. (For alternatives, see below 

And yes if you do choose to use 2x6s you would have to carefully set that deck block a bit lower into the soil to keep the deck surface level. But I would tell you that using 2x4s as joist Secondly you will have to have many, many deck blocks along the length of each 2x4. In fact you may have to have a block 

The backdoor opens onto a 8'x12' covered concrete patio which I'd like to extend 8' out and 12' over with a wooden deck, without removing the had a flat yard, little chance of heaving in the winter, etc. and we wanted a low-height unattached deck (for tax purposes), we used a product called deck blocks.

These instructions show how to assemble the framing on the beams and install the decking. Default profile photo get away with your posts contacting the ground with our code they must be set atop a structure such as a steel or concrete pile/footing to prevent wicking moisture, treated wood or not..

The advantage of a floating deck is that it is possible to be moved to any location in the yard. This is by no mean deck piers minimum 2x4 stud steel reinforcements The ground that we picked for our floating deck was uneven so I had to play a little with cinder blocks and bricks to level the frame. Once I was finished with 

Low Profile Deck Questions. I would like to place a deck over a concrete slab. The slab is only 6" below the outside door. Can I use 4x4 beams supported 1" above the slab with 2x4 as the joists?

Not only are they easier to build than standard decks, but they are also less scary to build for DIYers. Here is why: When you attach a deck to a building, you need to gain access to solid wood. This requires removing the siding of your house in that area (that is, if your house is covered with clapboard, vinyl 

After measuring the dimensions of the yard, Adam helps center the placement of the deck using strings tied to wood stakes (Image 1). Continually measure and adjust the If the yard slopes slightly away from the house, the lower holes need extra height to reach the level string. To remedy this, cut a cardboard caisson tube 

Building a low profile frame is necessary. You will need to use a flush beam which is set at the same level as the joists as opposed to a cantilever beam. If the bottom of your deck frame is less than 6" above the ground or partially buried you should use pressure treated wood that is rated for ground contact. The higher level 

We used a premium grade of low-maintenance composite decking with hidden fasteners, which brought the total cost to over $2,000, but using standard treated We used 11 joists spaced 12 in. on center to keep the composite decking we used from sagging over time, but wood decking can be spaced 16 in. on center.