use tongue and groove wood for deck flooring

Watch this video to find out how to install ipê flooring on a porch. Ipê is a dense, Ipê makes a great flooring material for porches and decks, since the wood is naturally resistant to moisture, fungus, insects, and rot. When using tongue and groove lumber, leave a small gap every few rows of flooring to allow for expansion.

Plank decking is tongue and groove lumber at least 38mm (1-1/2″) thick, with the flat or wide face laid over supports such as beams or purlins to provide a structural deck for floors and roofs. It is used where the appearance of the decking is desired as an architectural feature, or where the mass of decking is required to add 

For Tongue and Groove decking, a more aggressive pitch is recommended. We highly recommend using a 1/4" per foot slope. Framing material should be installed with the crown up (humps up) to aid in water draining off the surface material. Framing lumber can crown 1/8" or more, and may lead to standing water.

When it comes to Tongue and Groove decking, a significantly more aggressive pitch is encouraged. We highly suggest using a 1/4" per 1 ft. slope. Framing material should be installed with the crown up (humps up) to assist in water draining off the surface material. Framing lumber can crown 1/8" or greater, and may lead to 

Aluminum decking is available in standard plank with spaces and also with tongue & groove joints with gaskets for a watertight floor. Arid Dek aluminum decking and alumiLAST decking use a lap joint system to make a waterproof floor. AlumiLAST also has an aluminum framing system. Decorative steel grating systems are 

DIYNetwork.com experts give new life to a porch with easy-to-install flooring. Materials. felt paper; tongue-and-groove porch decking; nails. Show All Lock the boards into place, then face-nail the first row of boards, then use a pneumatic flooring nailer to nail each nail into the tongue of the board. Space nails evenly.

Although installing mahogany tongue-and-groove decking boards is similar to installing interior flooring boards, there are some key differences. You probably won't have a solid the joist within 3/4 inches of its end. To prevent the wood from splitting, drill pilot holes for the screws near the ends, using a 3/16-inch drill bit.

STUD USE ONLY or VERTICAL USE ONLY lumber can be used for studs under dry-use conditions when any bending or tension stresses are of short duration, such as for wind or earthquake . The maximum recommended joist spacing for installing Southern Pine tongue & groove porch flooring is 16 inches on center.

Tongue and groove planks were reserved for use under resilient flooring. The use of wood planks in floor and roof assemblies continued into the 1970s, although newer structures primarily use wood sheathing. Today, wood decking is used under some roofing material, and on ceilings, decks, patios, docks,